Forum Replies Created

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • in reply to: [REQUEST] Turn off flashing Tap button on BIM #613
    shwanton
    shwanton
    Participant

    +1

    Since there isn’t any power switch, when it’s not in use and just blinking it’s very distracting.
    I tend to unplug it but that is a bit inconvenient.

    in reply to: BIM freeze out of sync #587
    shwanton
    shwanton
    Participant

    I noticed this the other day, but I think it has to do with the timing of the freeze button since it’s a 1 sec slice.

    I would love to have these slices be adjustable to get nice quick repeating effects that can be modulated. Maybe after freeze is pressed, the buttons are division of the slice? That would be super sweet!

    in reply to: TAP Troubles with BIM #502
    shwanton
    shwanton
    Participant

    Awesome news!

    I’m not sure how feasible it is, but if there was a way to send a specific BPM value for delay time via midi CC?
    I know there is no readout on the screen for showing what the value is, but if it could be set via Midi CC it would be very nice.

    in reply to: TAP Troubles with BIM #475
    shwanton
    shwanton
    Participant

    I’ve also seen these issues with the tap button behavior when the midi settings are changed. If the midi clock to delay time is set to off, the tap button light will stop flashing when tapped manually.

    A factory restart will reset this back to it’s original value and the button will start working again.

    in reply to: Filter-only modification #474
    shwanton
    shwanton
    Participant

    Would love to give it a try if you ever post the instructions!
    Absolutely love the filter on the Biscuit!

    in reply to: [REQUEST] Send LFO to other parameters #468
    shwanton
    shwanton
    Participant

    Thanks for the response.

    I agree, it might be weird for a LFO to change only 4 values for the filters (unless you could do a combination of both!).
    Might be cool for a LFO w/ random S&H mode to play random filter values.

    Might still be cool for a slow LFO to effect the Feedback, Input gain, Offset and Division/Range parameters.

    Thanks for keeping it on the maybe list!

    in reply to: Low volume when sending mono #446
    shwanton
    shwanton
    Participant

    I think I’ve figured it out, I had a cable attached to the right input even though I was only getting mono input from the left. Volume is great now!

Viewing 7 posts - 1 through 7 (of 7 total)