Reply To: Ideas for BIM firmware upgrade

[rahiku]

I’m having a couple issues after the BIM firmware upgrade:

1) When using the reverse mode, the left channel sounds very distorted with much lower signal than the right, which sounds better than the left but still has quite a bit of distortion. No issues if I switch to another delay type.

2) I can’t change the TAP tempo display setting – I hold the TAP tempo button down when powering on the unit as instructed, but the button light stays flashing.

I’ve got SN# 839 if that makes any difference. Thru mode sounds great! Very cool way to use the filters as a separate effect.

Thanks!