HOME Forums BIM-BAM-BOUM BAM issue – no sound when on

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #546


    I have a weird one for you. My BAM worked fine on my pedalboard, but then I hooked it up as an insert for my DAW and now I get no sound when activated. It passes signal fine when bypassed, but as soon as I activate it, no sound. I checked the obvious mix-knob-being-down-while-in-aux-mode thing, but it doesn’t pass sound with the mix knob up all the way either. The only think I can think of is that I’m using XLR>TRS cables to hook it up. Will using TRS cables cause some weird tip-ring or ring-shield shorting when the relays activate? Thanks.

    Oto Machines

    Did you try a system reset ?
    Press ACTIVE and TAP switches while powering BAM.
    Please tell me if it works.
    The problem could also occurs with out of phase TRS cables (tip and ring inverted).
    All the best,

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.