HOME Forums BIM-BAM-BOUM BIM Feedback limiter

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #1857
    Anonymous
    Inactive

    Hi,
    I’ve beenn enjoying the BIM very much so far.
    However, i wish the setting on feedback limiter could be slightly more versatile.

    Would it be possible to add a limiter “ratio-ish” setting ?
    For exemple when you entered feedback limiter mode :

    Top led1/2 : ON/OFF
    By adding bottom led : ratio (position 1,2,3 & 4) with position of 4 almost innactive.
    Doing so we would be able to choose a feedback limitation (aka speaker insurance) while keeping a nice feedback movement.
    The limiter in some case have tendencies to cut the signal too shortly (at least to my taste).

    (I know that “ratio” stands better for Compressors but i don’t think we would benefit much for having a complete compressor before the limiter in the chain (neither we need the typical attack/decay, treshold functions of it imho).

    Thanks in advance
    Regards
    Sebastien

    #1898
    Oto Machines
    Keymaster

    Hi,
    Thanks for your suggestion. The feedback limiter is an analog hardware feature so we can’t add new settings on it with a firmware upgrade. Sorry !
    All the best,
    Denis

    #1925
    Anonymous
    Inactive

    Thanks for the reply.
    Ah, feedback path is part of the analog processing !
    I thought the limiter was after the 12bits AD/DA conversion.
    Sorry !

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.