Forum Replies Created

Viewing 1 post (of 1 total)
  • Author
  • in reply to: Ideas for BIM firmware upgrade #1297

    I’m having a couple issues after the BIM firmware upgrade:

    1) When using the reverse mode, the left channel sounds very distorted with much lower signal than the right, which sounds better than the left but still has quite a bit of distortion. No issues if I switch to another delay type.

    2) I can’t change the TAP tempo display setting – I hold the TAP tempo button down when powering on the unit as instructed, but the button light stays flashing.

    I’ve got SN# 839 if that makes any difference. Thru mode sounds great! Very cool way to use the filters as a separate effect.


Viewing 1 post (of 1 total)